56
3.OPERATIONS
INITIAL SETTING
BTM. DEC. LEVEL
BOTTOM DECISION LEVEL
High frequency
FISH FINDER SETTING
INITIAL SETTING
▲
▲
▲
▲
▲
INITIAL SETTING
MARK RETURN TO PREVIOUS MENU
GOTO SUB MENU
GRAPH CLOSE MENU
▼
▲▲
▲
▲
U
N
I
T
CALIBRATION
VR CURVE
BTM. DEC. LEVEL
EXT. TRIG. IN
EXT. SIG. IN
DATA INPUT
DATA OUTPUT
C CURVE
HI
LO
OFF ON
ON
OFF
LINEAR
0
0
▲▲
BOTTOM DECISION LEVEL
▲
▲
HI
LO
±00
±00
30
0
−
＋
30
MARK RETURN TO INITIAL MENU
GRAPH CLOSE MENU
Adjusting the bottom identification level (BOTTOM DECISION LEVEL)
The fishfinder picks the identification signals for identifying the bottom
and displaying "DEPTH", "BOTTOM LOCK mode", and "BOTTOM
DISCRIMINATION mode" data.
The bottom is identified automatically. However, if the bottom is heavily
laden with mud, sludge, and/or underwater plankton, the resulting noise
may cause a flickering display of the "DEPTH" value. Adjust the bottom
identification level in such a case.
Using the WHITE LINE function, specify the WHITE LINE level
separately as directed on page 44.
Outline of the procedure: Proceed from the FISH FINDER
SETTING menu to "WHITE LINE", "HI/LO", and data entry, in that
order.
The bottom identification level adjustment procedure is shown below.
1
Display the FISH FINDER SETTING menu by pressing the
and
keys together.
2
Move control to "INITIAL SETTING" by pressing the
or
key, and display the INITIAL SETTING submenu by pressing the
key.
3
Move control to "BTM. DEC. LEVEL" by pressing the
or
key, and display the BOTTOM DECISION LEVEL submenu by
pressing the
key.
4
Select either "HI" (high frequency) or "LO" (low frequency) by
pressing the
or
key.
5
Specify the appropriate identification level by pressing the
or
key.
1
The standard value is "0".
2
If the bottom is dirty with mud and sludge (under the
conditions that the edge of the bottom is not clear) and this
causes a flickering display of the water depth value, slightly
increase the identification level (change the level in its plus
direction on the screen).
3
If either the double reflection of the bottom or the fish or
plankton is mis-identified as the bottom, slightly reduce the
identification level (change the level in its minus direction).
6
Press the
MARK
key to return to the INITIAL SETTING submenu.
7
Press the
GRAPH
key to return to the fishfinding display.
FISH FINDER SETTING
HI
OFF
AUTO
▲▲
GOTO SUB MENU
GRAPH CLOSE MENU
▲
▲
▲
▲
▲
▲
▲
▲
INTERFERENCE
COLOR REJ.
FREQ. ADJUST
TX CYCLE MODE
1
2
3
4
5
6
7
8
SIGNAL PROCESS
INITIAL SET
STC MODE
TX CYCLE ADJ.
ADC MODE
TX PULSE WIDTH
WHITE LINE
P
D
C
1R1
0.0
LO
0.0
HI
D
D
LO
HI
200.0
50.0
LO
LONG
OFF
SYNC.
0
50
100
1
2
150
200
ASYNC.
SHORT
1R2
