Z2 Controller Operations Manual
Z2C Installation and Operation Manual
5-8
Interoperability Now
5.1.4.2
Bridge Channel Configuration on the Remote Resource
Now that the virtual JPS Bridge channel is configured on the Z2C (as outlined above), configure
the remote unit streaming to it. The following explanation will focus on the RSP‑Z2.
In the screenshot below, the RSP‑Z2 is configured for Independent Passthrough. In this example,
we are going to concentrate on Channel 1, which is connected to the VHF TAC radio system.
Important:
For ideal connection to the Z2C, the backhaul channel on the RSP‑Z2 should be
configured as a JPS Bridge channel.
Figure 5-5: RSP-Z2 Independent Passthrough Configuration with JPS Bridge Backhaul
In order to stream from the backhaul JPS Bridge channel to the Z2C, the backhaul channel must
be configured properly on the RSP‑Z2. Right click the JPS Bridge channel icon or select
Channel
from the
Settings
tab. Click to select the backhaul channel to display its settings.
Important
Basic Settings
configurations here are:
•
Type:
Bridge
•
Enabled:
Yes
•
Profile:
Bridge Defaults
Name
and
Description
will show up only on the RSP‑Z2 GUI, with the full name listed when the
cursor hovers over the icon, but they will not be visible on the Z2C. Name and description do not
affect operation.