Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
255/346
6.6.5
Function interface
A
Pay
function has been introduced in UniSAB III. In the future some new UniSAB III customer related
functions will be blocked until they are activated by entering a unique four digit code. This code can be
acquired from Sabroe sales.
When you try to configure a new customer related
Pay
function parameter such as
E-mail user
, the flag
E-mail user activate
must have been set in advance.
If this flag is not set, it will not be possible to change the Pay function parameter, not even with the
Supervisor password. But when the flag is set it will be possible to change the Pay function parameter
with the normal Superuser password.
The flag is set by using a unique four digit password – a
Code Entry
password. This unique four digit
Code Entry
password is tied up to the UniSAB III MAC address.
Pay function flags are activated in the picture
Setup/Session/Function Interface
:
When a function flag is selected you may activate the flag (function) by changing
No
to
Yes
. When doing
this you are prompted for the
Code Entry
password.
The normal Password pop-up menu is used for entering the
Code Entry
.
The keyed in
Code Entry
password(s) is stored in the HMISettings.xml file.
The following
Pay function options
are available at the moment:
E-mail user activate
Enable the function
Service/Event/E-mail user
Note: The
Pay
function
e-mail user
is default activated in version
1.0.9.6.
Rem. mon. activate
Enable the function
Service/Rem. Monitor/Remote mon.
Note: The
Pay
function
Remote Mon.
is activated as default in ver-
sion 1.0.9.4.
COP activate
Enable the function
Setup/Configuration/Plant/COP active
Once a pay function flag has been activated it cannot be deactivated. It is possible to activate or deacti-
vate associated configuration points, e.g.
E-mail user
.
Summary of Contents for SABROE Unisab III Control
Page 1: ...UniSAB III control Version 1 10 8 Engineering manual EN...
Page 2: ......
Page 347: ......
