Models
Revision 03-2012
116
Toucan 1210
Toucan 1310
!
CAUTION
10
Hold on to the bronze spacer and the washer
to prevent them from falling to the bottom of
the mast profile.
Install the roller before removing another one.
- Lower rollers
NOTE
Prior to removing the lower rollers, ensure
the upper rollers are installed.
Using the ground controls :
1- Raise the telescopic mast to access the roller
to be removed.
2- Unscrew the locknut from the roller pin to be
removed with a polygonal spanner.
3- Unscrew the roller pin to release the bronze
spacer and the roller as indicated previously.
Install the roller before removing another one.
- Rollers
The bronze spacer must be replaced if its
thickness is below 5 mm. Check the condition
of the roller pin, bushing and roller before
their installation. Replace damaged parts by
original parts. Grease the bushing before its
installation.
The rollers pins are generally delivered fitted.
To remove the bronze spacer, screw a locknut
on the pin until the roller and the spacer are
separated.
!
CAUTION
Roller installation tips :
- Partly tighten the pin on the mast section and
insert the washer on the pin.
- Apply grease on the spacer so that it "sticks"
to the mast and does not fall to the bottom of
the profile.
- Press the spacer on the mast profile and slide
it. The roller, spacer and pin must be in line.
- Tighten the pin so that the roller slides on the
pin.
- Reposition the spacer in line with the pin.
Tighten the pin completely until the spacer is
fully inserted.
- When the spacer is correctly inserted, loosen
the pin by 1 turn to prevent the mast from
jamming during the alignment adjustment.
Install the locknut without tightening it
(tightening of the locknut after mast alignement
adjustment).
Mast profiles must be clean before replacing
the bronze spacers. Mast profiles must be
greased after the spacers have been
replaced. The telescopic mast alignement
must be ajusted.
!
CAUTION
5 mm
Minimum thickness
of the bronze spacer
!
CAUTION
Grease
!
CAUTION
SERVICE - MAINTENANCE
7
7
