Models
Revision 03-2012
62
Toucan 1210
Toucan 1310
ELECTRICAL SYSTEM
4
4
4.2.6. Control-Adjustment of the tilt
indicator
Control :
Ensure the detector rests correctly on the support
capnuts.
1- Position the control panel selector on ( ).
2- Chock the rear wheels.
3- Place a spirit level (digital display) on the
chassis in the direction
(1)
-
(2)
.
4- Using a jack of sufficient capacity, lift the front
of the chassis in
(1)
:
ç
Stop as soon as the green light indicator
on the sensor switches off (jerks linked to
the manoeuvre stopped). Read the chassis
angle : value
(a)
.
5- Chock the front wheels.
6- Using a jack of sufficient capacity, lift the rear
of the chassis in
(2)
.
ç
Stop upon extinction of the indicator: value
(b)
.
7- Place the spirit level on the chassis in the
direction
(3)
-
(4)
.
8- Using a jack of sufficient capacity, lift the right
hand side of the chassis in
(3).
ç
Stop upon extinction of the indicator: value
(c)
.
9- Using a jack of sufficient capacity, lift the left
hand side of the chassis in
(4)
.
ç
Stop upon extinction of the indicator: value
(d)
.
PB1 :
Tilt indicator to replace.
PB2 :
Tilt indicator to replace.
PB3 :
Adjust
Adjustment:
- Position the machine with chassis horizontal
in all directions
(1) (2)
&
(3) (4)
(Blocks under
the wheels) : installation tolerance : ± 0,1°.
- Remove the protection on the calibraion wire.
Link the latter to the - on the battery until the
detector green indicator flashes.
ç
The detector is set. Install the protection.
NOTE
If a symetry fault is corrected, the setting must
be checked again in both directions before
the machine is returned to service.
1
2
3
4
Spirit level
Niveau
électronique
Recordings Values admitted Otherwise see
a + b
(c+d) ± 0.2°
PB1
a + b
c + d
a
b
c
d
3.6° to 4.4°
PB2
1.8 to 2.2°
PB3