Models
Revision 03-2012
110
Toucan 1210
Toucan 1310
BATTERY - CHARGER
5
5
5.2.2 Electronic charger "Oldham-
Hawker" CP IV
Supply
Adaptation to the network voltage
Prior to any operation requiring charger
cover removal, the battery must be
disconnected and the charger must be
unplugged from the AC source. Failure to do
so may result in serious or lethal injuries.
e
d
b
f
c
g
a
DANGER
Protections
Display panel
a.
Normal charge indicator (green).
b.
Second charging rate indicator (yellow).
c.
End of charge indicator (green).
d.
Default led indicator (red).
e.
Ah applied into the battery : 4 LEDs (from right to
left : 100% - 75% - 50% - 25%).
f.
Switch ON/OFF.
g.
Circuit breaker.
Troubleshooting
If a fault occurs during the charge, the charger stops, the Led "
" lights up and the bar chart Rep. E indicates
an error code.
Refer to the charger's documents.
Supply voltage
230 V eff.
110 V eff.
Frequency
Current absorbed
11 A eff.
22 A eff.
50 / 60 Hz
230 VAC - 50 Hz
110 VAC - 50/60 Hz
brow
n
blue
blue
brow
n
Bridges
Entry circuit breaker
On panel
32 A
Output fuse
Inside machine
100 A
Protection electronic card
Inside machine
—
The first LED flashes
Voltage still below 1,7 V per cell = 20.4 V for batteries after
1 minute of charge
Battery too discharged, contact Product Support.
The 2nd LED flashes
Voltage still below 2,05 V per cell = 24.6 V for batteries after
1 hour of charge
Problem with the charger , or battery too discharged. Switch the
charger off, disconnect the charger from the battery, wait for
approx. 15 mn. Reconnect the charger to the battery and switch
the charger on. If the problem persists the charger is faulty.
The 3rd LED flashes
Voltage per cell still below the required gazing voltage after
10 hours of charge.
The 4th LED flashes
Charging safety time exceeded (16 hours).
Charge interruption due to a power cut. The charge will be
resumed as soon as the power returns.
Check power supply.
The 4 LEDs flash
Voltage per cell 140% above the nominal values.
Battery already charged.
D
ef
au
lt
L
E
D
f
la
sh
es
D
ef
au
lt
L
E
D
li
g
h
ts
u
p
SOLUTION
Battery too discharged. Switch the charger off, disconnect the
charger from the battery, wait for approx. 15 mn. Reconnect the
charger to the battery and switch the charger on.
SIGNALLING
CAUSE
CURRENT LEDs INDICATOR