S e c t i o n 4
© 2020, JAPAN CASH MACHINE CO., LTD.
4 - 1
This section provides disassembly and reassembly
instructions for the UBA™ Pro Series Universal
Banknote Acceptor (UBA Pro).
This section contains the following information:
LED Light Module and Upper Bar Sensor Removal
Centering Motor Harness Assy. Removal
Entrance Motor Harness Assy. Removal
PB Motor Harness Assy. Removal
Stack Motor Harness Assy. Removal
Transport Motor Harness Assy. Removal
Tool Requirements
The following tools will be required to perform
disassembly and reassembly.
•
#1 Phillips Screwdriver
•
Flat Blade Screwdriver
•
E-Ring Tool
•
Tweezer
UBA Pro and Cash Box Removal
To remove the UBA Pro and the Cash Box out of
the Frame, proceed as follows:
1. Pull the Lever (Figure 4-1
a
) to release the lock.
2. Slide and remove the UBA Pro Unit (Figure 4-1
b
) from the Frame (Figure 4-1
e
) as illustrated by
the Arrow
①
.
3. Pull the Cash Box Handle (Figure 4-1
c
) to
remove the Cash Box (Figure 4-1
d
) from the
Frame (Figure 4-1
e
) in the direction indicated by
Arrow
②
.
LED Light Module and Upper Bar
Sensor Removal
To remove the LED Light Module and the Upper
Bar Sensor, proceed as follows:
1. Remove the two (2) Screws (Figure 4-2
a
1
&
a
2
).
2. Release the six (6) Locking Tabs (Figure 4-3
a
1
through
a
6
), and remove the Top Cover (Figure 4-
b
).
4 DISASSEMBLY/REASSEMBLY
NOTE: Calibration is required after
reassembly. (Refer to “Calibration and
Figure 4-1
b
a
c
d
①
②
e
Figure 4-1
UBA Pro and Cash Box Removal
Figure 4-2
LED Light Module and Upper Bar
a
1
a
2
Figure 4-2
LED Light Module and Upper Bar
Sensor Removal 1
Summary of Contents for UBA Pro Series
Page 8: ...P N 960 000211R_Rev A 2020 JAPAN CASH MACHINE CO LTD v i THIS PAGE INTENTIONALLY LEFT BLANK...
Page 14: ...P N 960 000211R_Rev A 2020 JAPAN CASH MACHINE CO LTD x i i THIS PAGE INTENTIONALLY LEFT BLANK...
Page 16: ...P N 960 000211R_Rev A 2020 JAPAN CASH MACHINE CO LTD x i v THIS PAGE INTENTIONALLY LEFT BLANK...