JCM GLOBAL UBA Pro Series, Operation And Maintenance Manual

Page: 96 / 132

P/N 960-000211R_Rev. A © 2020, JAPAN CASH MACHINE CO., LTD.
6 - 2 6
Section 6 UBA™ Pro Series Universal Banknote Acceptor Calibration and Testing
Entrance and Feed Motors

Simultaneous Operation Test
(Reverse)
To perform the Motor Operation Test of the Entrance
Motor and the Feed Motor in the reverse rotation at the
same time, proceed as follows:
1. Remove electrical power.
2. Set the DIP Switches as below (Figure 6-137).
3. Apply electrical power.
4. Confirm that the
Green and Red Status LEDs are
lit.
5. Lift up on the Upper Guide Access Lever to open
the UBA Pro’s Cover
6. To start the Test, set the DIP Switch #8 to
OFF
(Figure 6-139).
7. The Rollers will start running in the reverse
direction when the Entrance and Feed Motors
function properly.
8. Set the UBA Pro DIP Switch #8 to
ON
to end the
test.
Figure 6-137 Entrance and Feed Motors
Simultaneous Speed Test (Reverse) 1
Figure 6-137 Entrance and Feed Motors

Simultaneous Speed Test (Reverse) 1
DIP Switches #2, #5, #6, #8 ON
ON
1 2 3 4 5 6 7 8
Figure 6-138 E
Figure 6-138 Entrance and Feed Motors

Simultaneous Speed Test (Reverse) 2
Green Red
Figure 6-139 Entrance and Feed Motors
Simultaneous Speed Test (Reverse) 3
Figure 6-139 Entrance and Feed Motors

Simultaneous Speed Test (Reverse) 3
DIP Switch #8 OFF
ON
1 2 3 4 5 6 7 8
Figure 6-140 Entrance and
Figure 6-140 Entrance and Feed Motors

Simultaneous Speed Test (Reverse) 4