JAI VIS-CAM System, Installation Manual

Page: 31 / 112

Installing the Vehicle Imaging System 19
VIS-CAM Systems
Figure 17. TLS-300 signal and power cable.
3. Route the Traffic Light Sensor end of the TLS-300 signal and power cable through the mounting
pipe and the flange (see Figure 18)
4. Screw the flange onto the pipe, finger-tight, to allow
subsequent minor adjustment
5. Attach the cable connector to the Traffic Light Sensor
6. Attach the Traffic Light Sensor body to the flange and
secure it with the four Allen screws
7. Orient the Traffic Light Sensor such that the white
reflectors are parallel to the trigger plane with side B
facing (visible from) the trigger plane
8. Route the free end of the cable to the VIS J-Panel in
accordance with the local code requirements
9. Connect the color-coded wires to J-Panel connector
X3 as described in Section 3.3, Section 6.4 and
Section 6.7. Make sure that no power is applied when
performing any wiring operation.
Figure 18. Installing the TLS-300 through
the mounting pipe and flange.
Table 1 Light Sensor Cables
PIN# Wire color Signal PIN# Wire color Signal
1 White/green Heater gnd 10 White Gnd
2 Green Heater gnd 11 - nc
3
Red/blue 24V dc
12
- nc
4
Blue/red 24V dc
13
Brown D1-
5
- nc
14
White/brown D1+
6
Yellow +24V dc
15
Orange D0-
7
- nc
16
White/orange D0+
8
- nc
-
Black Shlds
9 - nc