JAI VIS-CAM System, Installation Manual

Page: 91 / 112

Appendix B 79
VIS-CAM Systems
If separate lane controllers are to be connected to the two cameras, databus D0 is connected to Camera #0 and
databus D1 is connected to Camera #1. Switch S2 must then be in position “TERM”. The 120 ? termination
resistor is then connected between the RS485 wires.
Figure 89. Lane controller setup diagram.
6.12.2 Connector specification
Connector type: 5 pole WAGO pluggable terminal block
Connector on board: WAGO 734-235
Cable part: WAGO 734-205
6.12.3 Connector signal specifications
D0 and D1 are RS485 data bus signals from the Lane Controller.
6.12.4 Connector physical Interface
Table 32 WAGO physical interface
Pin Signal Description Connection to
1 D0+ RS485 databus D0+
2 D0- RS485 databus D0-
3 Gnd
4 D1+ RS485 databus D1+
5 D1- RS485 databus D1-
6.12.5 Connecting Lane Controller RS485 signal between J-Panels
The Lane Controller RS485 signal is connected from one J-Panel to another by connecting RJ45 Patch cables
between X4 on the source J-Panel to X5 on the receive J-Panel. The RJ45 connectors have build-in switch
function to disconnect the termination resistor when the plug is inserted. When no plug is inserted into the X4
connector the line is terminated with 120 ?.
The Lane Controller is connected to D0 on X15 J-Panel #1.