![background image](http://html1.mh-extra.com/html/jai/vis-cam-system/vis-cam-system_installation-manual_3223355062.webp)
VIS-CAM Systems
50
Appendix A
5.3.3
Connector signal specifications
Description
Logic inverter powered by 5V drives the output. The inverter is a HCMOS type 74AHC14.
Output signal specification
Signal amplitude5V TTL
Output impedance100 Ω
Pulse width5 ms ± 1 ms
Signal polarityactive high
External power requirement
Voltage8-26V DC
Currentmax 25μA
Electrical Interface on the I/O board:
Figure 51.
I/O board electrical interface. Test
A push button switch S1 can be activated for generation of an output pulse for test purposes. The flash output
is high as long as the switch is activated. The switch is located as shown on Figure 52:
Figure 52.
Switch location.
5.3.4
Connector physical Interface
Table 12
Wiring diagram.
Pin
Signal
Description
Connection to
1
I/O Gnd
IO Board Gnd
Pin 2 when no power is available from the flash
2
GND
Flash Gnd
Flash ground (negative power terminal)
3
Out
Strobe Out
Strobe input on flash unit
4
Stat
Strobe status
Status output from flash unit
5
FPWR
Flash power
Power from flash to output circuit on I/O Board
6
24V
IO board 24V (Fused 0.5A) Pin 5 when no power is available from the flash
Summary of Contents for VIS-CAM System
