JAI VIS-CAM System, Installation Manual

Page: 97 / 112

Appendix E 85
VIS-CAM Systems
Gateway:Enter the default gateway of the unit.
IP Configuration:Specify whether the unit uses static of dynamic IP address.
DNS Server 1 Specify primary DNS server to be used by the unit.
DNS Server 2 Specify secondary DNS server to be used by the unit.
SNMP. Enables / Disables the SNMP protocol.
Auto report to IP: Reports generated by the auto report function will be automatically be forwarded to IP
address specified in this field.
Auto report to TCP Port:Specify the TCP port number for the auto report function. The default port is 4002.
Auto report period: Time interval for error reporting.
Figure 94. Standard configuration of Network Settings:
Serial port 1 settings:
Port alias: D1 – enter desired name of this specific serial port.
Baud rate: 9600 – specify the desired baud rate of the serial port – the TLS200 light sensor requires 9600 as
standard.
Data bits: 8 – specify the desired size of the data bits used - the TLS200 light sensor requires 8 as standard.
Stop bits: 2 – Specify the desired size of the stop bits used - the TLS200 light sensor requires 2 as standard.
Parity: None – feature not used in communication with the light sensor.
Flow control: None - feature not used in communication with the light sensor.
Fifo: Enable - the TLS200 light sensor requires FIFO as standard.
Interface: RS-485 2wire – the communication with the TLS-300 light sensor is standard 2-wire RS-485.
Enable – apply the above settings to all serial ports – rename port 2 port alias to D0.