![background image](http://html1.mh-extra.com/html/jai/vis-cam-system/vis-cam-system_installation-manual_3223355032.webp)
VIS-CAM Systems
20
Installing the Vehicle Imaging System
3.1.2
Optional Side Mount
1.
Attach the pipe clamps approximately 6-inches apart on a vertical mounting surface as
shown in Figure 19.
2.
Loosen the four Allen screws and remove the flange from the mounting base. Figure 16,
“Install the traffic light sensor”.
3.
Route the Traffic Light Sensor end of the TLS-300 signal and the power cable through the
pipe and flange.
4.
Screw the flange onto the pipe somewhat tightly to
allow subsequent minor adjustment
5.
Place the pipe in the pipe clamps and tighten them
to secure the pipe to the vertical mounting surface.
6.
Attach the Traffic Light Sensor body to the flange
and secure it with the four Allen screws.
7.
Orient the Traffic Light Sensor such that the white
reflectors are parallel to the trigger plane with side
B facing (visible from) the trigger plane
8.
Route the free end of the cable to the VIS J-Panel in
accordance with local code requirements
9.
Connect the color-coded wires to the J-Panel
connector X3 as described in Section 3.3. Make sure
that no power is applied when performing any wiring
operation.
Figure 19.
Pipe clamps should be
about 6-inches apart
on a vertical surface.
3.2
Installing the Camera(s)
In general, the camera(s) should be aimed at the most likely cross-lane position of the vehicle license plates.
See “Installation Preparation” in Section 2 for general site layout guidelines. To install the camera(s):
1.
Attach the camera mount to the camera enclosure using the included mounting bolts and washers.
Figure 20.
Camera Installation
Summary of Contents for VIS-CAM System
