JAI VIS-CAM System, Installation Manual

Page: 85 / 112

Appendix B 73
VIS-CAM Systems
6.7.1 Functionality
The J-Panel has one input for 24V DC (X6). There is one unfused output (X7) and four fused outputs for Camera
0 (connector X1, fused 2A), Camera 1 (connector X2, fused 2A), Light Sensor (connector X3, fused 2A) and
RS485-to-ethernet Converter (connector X8, fused 300mA).
It is possible to reset all fuses and they also reset automatically (PTC type) after removal of excessive load. The
three power LED indicators are electrically located between the fuse and connector and the status of the fuse
is therefore indicated on the LED: when the LED is green the load is ok, when the LED is red an overload
condition is present.
Figure 81. Principle in the power distribution.
6.7.2 Connector specification
Connector type: 2 pole WAGO pluggable terminal block
Connector on board: WAGO 734-232
Cable part: WAGO 734-202
6.7.3 Connector signal specifications
24V DC power input. The two connectors are connected in parallel (unfused).
Maximum total current to X1, X2, X3 and X8: 6,3 A (fused value)
6.7.4 Connector physical Interface
Table 27 Physical connection for pins.
Pin Signal Description Connection to
1 +24V +24V DC 24V DC power supply
2 GND +24V return 24V DC power supply