jablotron JA-60 "Comfort", Installation Manual

Page: 19 / 34

Alarm system JA-60 "COMFORT" - 19 - MDY51319
8.28. New service code setting sequence: 5 nSC nSC
The Service Code can be used to enter the programming mode. A new Service Code must be entered twice in the se-
quence to avoid an error.
To change the code enter:
5 nSC nSC
where nSC is your new Service Code (four digits)
Example: to change service code to 1276 enter: 5 1276 1276
Factory default setting: service code is 6060
8.29. User Mode entering Sequence: 6 9 9 9
This sequence is used to switch from the Service Mode to the User Mode, where you can set zones´ bypass (see User´s
manual). You can exit the User Mode by pressing the “N” button. The bypassed zones will remain active after the leaving
the User Mode.
9. Voice & Pager messages setting
A control panel equipped with a telephone dialer can automatically send a voice message(s) and a code to a Pager. The most conven-
ient programming of the dialer is via a connected PC using the Comlink software (see 14). Programming can also be performed by
entering programming sequences from the system keypad while in the control panel programming mode:
•
Enter the programming mode (entering F 0 SC - SC = Service Code, factory default SC=6060), indicated by a „P“ on the display.
This can only be done while the panel is disarmed.
•
The parameters of the dialer can be set by entering programming sequences from the keypad. Any unfinished programming se-
quence can be terminated by pressing the N key.
•
To exit the programming mode, press the N key („P“ will turn off). If any fault is indicated when you try to exit the programming
mode, the control panel will inform you about the problem (see 8.20.).
•
Telephone numbers and the voice message can also be set up in the User Mode when enabled (see 8.6.2.)
List of the voice & Pager programmable parameters
Function sequence options factory d. note
Dialing method 90x 901 = tone 900 = pulse tone
Triggering of the dialer with a Panic alarm
91x
911 = YES 910 = NO 911
Triggering of the dialer with an Intruder alarm 92x
921 = YES 920 = NO
921
Triggering of the dialer with a Fire alarm 93x 931 = YES 930 = NO 931
Triggering of the dialer with a Tamper alarm 94x 941 = YES 940 = NO 941
Triggering of the dialer with a Technical alarm 95x
951 = YES 950 = NO 951
Telephone line checking enabled 99x
991 = YES 990 = NO
NO
Store telephone numbers for voice message 7xx..x F y xx...x = tel. number, y = mem-
ory 1 to 4, pause = F0
Pager dialing programming 7x.xF9z..zF5 x..x = provider tel. number z..z
= pager message
1:
2:
3:
4:
5:
Erase telephone number
7F0Fy
y = memory 1 to 5, entering
7F0F0 erases all
Record voice message 8 0 (hold 0 and talk to control panel)
2 messages - see 9.2.
9.1. Telephone numbers entering
sequence: 7xxx....xxFy
Store telephone numbers for voice message entering:
7 xx... xx F y
where
xx...xx
= telephone number
y
= memory number from 1 to 4
A telephone number can have a maximum of 16 digits. A pause can be entered with F0
(pause can not be entered as the first
digit).
Example: to store tel. number 483 123456 to memory no. 2 enter: 7 483 F0 123456 F2