Itm ITM 800, Operating Instructions Book Manual

Page: 101 / 118

Maintenance and adjustment
95
4
minated, the bulbs being removable from
the rear of the switch assembly.
To replace the bulb:
1. Remove the screws retaining the switch
panel (1 Fig. 73)
2. Remove the wiring plugs (2) from the
switch (3) with the failed bulb.
3. The switch is retained by a sprung tag (1
Fig. 74) at either end. Press in the tags
and remove the switch assembly.
Fig. 74:
1
2
3
4
4. To change the bulb, press in tag (2 Fig.
74) using a small screwdriver and pull
the bulb retainer (3) from the back of
the switch.
5. The bulb (4) is of the capless type, and
is a push fit in the retainer.
6. After changing the bulb, push the re-
tainer into the back of the switch until
the tag locates in the aperture.
7. Replace the switch, plugs and panel.
Direction indicator warning lights
(Fig. 75)
1. Remove the right hand lower instrument
panel as described above.
2. Remove the two plugs.
3. Press in the two tags (1) to remove the
light (2) from the panel.
Fig. 75:
3
2
1
4
4. Ease the bulb holder (3) to the right and
pull.
5. The bulb (4) is of the capless type, and
is a push fit in the retainer.
6. After changing the bulb, push the re-
tainer into the back of the switch until
the tag locates in the internal grove.
7. Replace the light holder, plugs and pan-
el.
Interior Light (Fig. 76)
To replace the interior light bulb, re-
move the lens fit a new bulb and replace
the lens.
Fig. 76: