SECTION 12—WIRING ASSEMBLIES
82
6. Secure the new transformer to the base with the two mounting screws (Detail “A”).
Securely tighten
7. Connect the transformer assembly wire harness to the circuit board (Detail “B”).
8. Install the control panel. Refer to Removing/Installing Control Panel on page 29.
9. Install the cabinet. Refer to Removing/Installing the Cabinet on page 25
FIGURE 12.2
Replacing Transformer Assembly
Replacing Bleed Resistor Assemblies
Units Manufacture Before 7/3/06
NOTE: For this procedure, refer to FIGURE 12.3 on page 83.
1. Remove the cabinet. Refer to Removing/Installing the Cabinet on page 25.
2. Disconnect bleed resistor assembly 1 from the power inlet (Detail “A”).
3. Disconnect the bleed resistor assembly 1 from the grounding clip on the motor
assembly (Detail “B”).
4. Disconnect bleed resistor assembly 2 from the control panel (Detail “C”).
5. Disconnect the bleed resistor assembly 2 from the grounding clip on the motor
assembly (Detail “B”).
6. Connect one end of the new bleed resistor assembly 1 to the power inlet.
7. Connect the other end of the new bleed resistor assembly 1 to the grounding clip on
the motor assembly.
8. Connect one end of the new bleed resistor assembly 2 to the other connection point on
the grounding clip on the motor assembly.
9. Connect the other end of the new bleed resistor assembly 2 to the control panel.
10. Install the cabinet. Refer to Removing/Installing the Cabinet on page 25.
Mounting Screw
DETAIL “A”
DETAIL “B”
Transformer
Assembly Wire
Harness
Circuit Board
Connector
Transformer Assembly Wire Harness
