SECTION 6—PANEL ASSEMBLY
28
SECTION 6—PANEL ASSEMBLY
Replacing Exhaust Fan
NOTE: For this procedure, refer to FIGURE 6.1.
Tools required for this procedure are:
• Phillips screwdriver
• Torque Wrench
1. Remove the cabinet. Refer to Removing/Installing the Cabinet on page 25.
2. Note the wire orientation of the two wires located on the exhaust fan.
3. Disconnect the two wires from exhaust fan wire connectors.
4. Remove the four mounting screws securing the fan inlet seal to the exhaust fan (Detail
“B”).
5. Set the fan inlet seal aside for re-use.
6. Remove the four mounting screws securing the exhaust fan to the isolator plate.
NOTE: Before securing exhaust fan in place, ensure airflow arrow (molded into the side of the fan)
points toward the back and out of the unit.
7. Secure the exhaust fan to the isolator plate with four mounting screws. The mounting
screws MUST be torqued to 20–30 in-lbs (2.26-3.39 Nm).
8. Secure the fan inlet seal to the exhaust fan with four mounting screws. The mounting
screws MUST be torqued to 20–30 in-lbs (2.26-3.39 Nm).
9. Connect the two wires to the exhaust fan in the orientation previously noted.
10. Install cabinet. Refer to Removing/Installing the Cabinet on page 25.
FIGURE 6.1
Mounting Screw
Fan Inlet Seal
DETAIL “A”
DETAIL “B”
Mounting
Screws
Isolator Plate
Fan Mounting
Bracket
Mounting
Screws
Isolator Plate
Wire
Connectors
(Not shown)
Exhaust Fan
Airflow
Arrow points
to back of
unit
