SECTION 7—BASE COMPONENTS
35
Removing/Installing the Power Inlet
NOTE: For this procedure, refer to FIGURE 7.2.
Tools required for this procedure are:
• Phillips screwdriver
• Torque Wrench
Removing
1. Remove the cabinet. Refer to Removing/Installing the Cabinet on page 25.
2. Remove the two mounting screws that secure the power inlet to the base.
3. Slowly pull the power inlet out of the base assembly to expose the wire connections.
4. Note the location of the wire connector and dual terminal connector before
disconnecting the wire connectors from the power inlet.
NOTE: The dual terminal connector houses the top and middle wire connectors.
5. Disconnect the bottom wire connector from the power inlet.
6. Disconnect the dual terminal connector from the power inlet.
7. Discard the existing power inlet.
Installing
1. Connect the dual terminal connector to the new power inlet.
2. Connect the bottom terminal connector to the new power inlet.
3. Secure the power inlet to the base with two mounting screws. Torque the mounting
screws to 20–25 in-lbs (2.26-2.82 Nm).
4. Install the cabinet. Refer to Removing/Installing the Cabinet on page 25.
FIGURE 7.2
Removing/Installing the Power Inlet
Mounting Screws
Top Wire
Connector
Base
Power Inlet
Middle Wire
Connector
Bottom Wire
Connectors
NOTE: Top and Middle
wire connectors attach
to dual terminal
connector.
