Invacare HomeFillII AW, Service Manual

Page: 59 / 104

SECTION 10—COMPRESSOR REPLACEMENT
Part No 1154316
59
HomeFill
®
II AW Compressor
SECTION 10—COMPRESSOR
REPLACEMENT
HomeFill Units Manufactured Before 8/1/05
Tools Required:
7
/
16
open ended wrench,
5
/
8
open ended wrench, Diagonal Cutters,
Needle Nose Pliers, Phillips screwdriver
Disassembly
NOTE: For this procedure, refer to FIGURE 10.1 through FIGURE 10.5.
1. Install an empty cylinder onto the compressor to release the pressure in the lines.
2. Remove the cylinder. Refer to Removing/Installing the Cabinet on page 25.
3. Disconnect power from the HomeFill unit.
4. Remove the cabinet. Refer to Removing/Installing the Cabinet on page 25.
5. Disconnect the two pin connector that connects the motor to the wiring harness
(FIGURE 10.1).
6. Using needle nose pliers, disconnect the two wires from the capacitor (FIGURE 10.1).
7. Using needle nose pliers, disconnect the grounding clip from the motor
(FIGURE 10.1).