Intermec VT220/ANSI, Programmer'S Reference Manual

Page: 214 / 276

SECTION 9
"
Extended Commands
9-8 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Code Description Column
0 Good status, transaction complete. (None)
1 Not enough memory. Or, incorrect
setting for speed, number of data bits,
number of stop bits, or flow control
timeout.
4, 6, 7, 11--12
2 No delimiter (#) on data stream. (None)
3 Timeout while using CTS flow control. (None)
4 Timeout while using DTR flow control. (None)
5 Timeout while using XON/XOFF flow
control.
(None)
6 Improper return field. (None)
7 Hexadecimal value is outside the range
of 00--0F.
15--16, 19--20
8 Reserved. (None)
9 Incorrect setting for maximum charac-
ters to receive.
13--14
A Incorrect setting for delimiter charac-
ter.
15--16
B Incorrect setting for number of delim-
iter characters.
17--18
C Incorrect setting for CTS flow control,
DTR flow control, or XON/OFF flow
control.
8, 9, 10
D Incorrect setting for start character. 19--20
E Incorrect setting for data parity. 5, 22
f/F * Timeout. (None)
p/P * Data parity or framing error. (None)
R Syntax error from RD5500 Remote
Display (not the expected character;
no character error was detected).
(None)
o/O * Overrun of UART receive register. (None)
* An uppercase letter indicates an error from the RS-232
device. A lowercase letter indicates an error from the
RD5500 Remote Display.