Intermec Transaction Manager 9560, User Manual

Page: 45 / 309

Preparing to Install the 9560
2-17
2
Intermec recommends using a cable capable of passing the VW-1 vertical flame
test. The following table lists Belden cables that meet these requirements.
Belden Cable Meeting Multi-Drop Requirements
Nominal Nominal
Belden Part VW-1 Test Gauge Impedance Capacitance 6 dbv
9729 No 24 100 12.5 2100
8102 No 24 100 12.5 2100
8162 No 24 100 12.5 2100
82729 UL Listed (60°C) 24 100 12.5 2100
89729 UL Listed (200°C) 24 100 12.5 2100
Note: Belden cable #89729 has the additional feature of being UL listed for use in an air plenum without being in
conduit - NEC Article 725, UL classified, Class 2 Circuits).
You can make open, unshielded, connections between cable sections with heat
shrink or other applied protection. Keep the unshielded section shorter than 2.0
inches (5.08 cm). You do not need a shielded box for connections.
Connect sections to the concentrator or the 9560 at pin 1 of the selected channel,
as shown in the following diagram.
Cable/Connector Diagram for Multi-Drop Wiring
Shield
TXDB
TXDA
RXDB
RXDA
1
4
6
8
9
GND
RXDB RXDA
TXDB TXDA
1
13 16 19 14
GND
RXDB RXDA
TXDB TXDA
1
13 16 19 14
GND
RXDB RXDA
TXDB TXDA
1
13 16 19 14
Devices
9-Pin D Sub Male
Port Concentrator
9560-09U