Intermec EasyCoder 4100, User Manual

Page: 236 / 282

7-66
FrGoth
4100 Bar Code Label Printer User's Manual
Helvitica condensed 9 pt italic
Co d e 39 18 p t
Test and Service Mode Commands
The following table gives descriptions of the test and service mode commands.
To enter Test and Service mode from Print mode, send <ESC>T from the host
terminal.
Note: All commands in Test and Service mode end with the command terminator (;),
except the last command in a message.
Command Code Summary Description
A Transmit Ambient
Temperature* Transmits the ambient temperature sensor A/D output back
to the host. The value ranges from 00 to 255.
B Begin Printhead Resistance
Test* Causes the printer to begin the printhead resistance test. The
printer responds with the ASCII character string "pass" or
"fail".
C Print Pitch Label* Causes the printer to print the pitch label.
D Reset Factory Defaults Sets the printer configuration to the factory defaults. When
you exit Test and Service mode after sending this command,
the printer performs a warm boot (it resets).
G Transmit Transmissive
Sensor Value Transmits the label gap transmissive sensor A/D output
back to the host. Value ranges from 00 to 255.
K Dark Adjust* This command changes the darkness of the print on your
labels. It is for fine-tuning only.
L Transmit Label Path Open
Sensor Value* Transmits the paper path open switch value back to the
host. A value of 0 indicates the paper path is open and a
value of 1 means it is closed.
M Transmit Reflective Sensor
Value Transmits the label mark reflective sensor A/D output back
to the host. Range of the value is 00 to 255.
P Transmit Printhead
Temperature Sensor Value This command transmits the printhead thermistor A/D
output back to the host. Range of the value is 00 to 255.
Q Print Quality Label Causes the printer to print out the print quality program
and model number label.