Intermec EasyCoder 4100, User Manual

Page: 210 / 282

7-40
FrGoth
4100 Bar Code Label Printer User's Manual
Helvitica condensed 9 pt italic
Co d e 39 18 p t
Printer Language, Select
Purpose : Selects the printer language.
Default : n=0
Syntax
:
<SI>l{n}
0 USA 5 Sweden
1 United Kingdom 6 Italy
2 Germany 7 Spain
3 Denmark 8 8-bit ASCII
4 France 9 Switzerland
Notes : Only one language is used per print job. See the
Appendix for international character sets.
This command is effective upon execution.
Printhead Pressure, Set
Syntax :
<SI>H{n}
Notes : The 4100 printer ignores this command.
Printhead Test Parameters, Set
Syntax
:
<SI>U{n}{,m}{,p}{,q}
Notes : The 4100 printer ignores this command.
Ribbon Save Zones, Set
Purpose: Defines the start and stop points of a ribbon save zone
within the label. This command does not enable inter-label
ribbon save.
Syntax
:
<SI>Z{n,m}
n and m are the zone start and zone stop distances, in dot
increments, from the detected front of the label.
The
difference between m and n depends on the speed
(number of ips) at which you are printing. Refer to the
table on the next page. Also, m must be bigger than n by at
least 100, or the command will be ignored.