5-23
Troubleshooting
5
Helvitica condensed 9 pt italic
Co d e 39 18 p t
Setting the Y Forms Adjust
With the Y Forms Adjust feature, you can control the position of the image in
the direction parallel to the printhead. For information on how to move the
image forward a number of dot increments, see the Dot Increments DIP Switch
Settings table. If your label is too close to one edge of the printhead, you can use
this feature to adjust it.
To set the Y Forms Adjust
1. Power off the printer.
2. Enable Test and Service mode by moving Switch 8 on the bottom bank of
DIP switches to the 1 or on position.
3. Turn on the power to the printer. The printer is now in Test and Service
mode.
4. In the top bank of the Test and Service DIP switches, turn on Switches 1, 2,
and 3. Turn off Switch 4.
5. In the bottom bank of the Test and Service DIP switches, turn on or off the
appropriate DIP switches. See the Dot Increments DIP Switch Settings table
to set the X forms adjust forward or backward a given number of
increments.
6. Press the [FEED] button. The printer prints out the software configuration
label.
7. Verify the Y Forms Adjust number on the software configuration label
matches the number you set in Step 4.
8. Exit Test and Service mode by cycling the printer power and returning the
DIP switches to their original settings.
Summary of Contents for EasyCoder 4100
