SKYZER TECHNOLOGIES
PAGE 33 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE
Version 1.00
5.3 EFTPOS CONFIGURATION FOR MULTI-MERCHANT
For a multi-merchant terminal each merchant has its own configuration.
Prior to configuring the terminal for multi-merchant, refer to page 35 to setup
the required number of active merchants on the terminal. Once assigned then
proceed with the following steps to configure the terminal for multi merchant.
Step Terminal Display
Comment
1.0
Press FUNC
2.0
FUNCTION?
Enter 3824 and press ENTER.
3.0
CONFIG PARAMS?
ENTER OR CLEAR
ENTER to configure the parameters, CLEAR to cancel and exit to idle prompt.
4.0
1 MERCHANT 1
2 MERCHANT 2
3 MERCHANT 3
Select the corresponding number on the terminal to select the Merchant to proceed
with configuration followed by ENTER.
5.0
TERMINAL ID?
XXXXXXXX
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press ENTER.
6.0
MERCHANT ID?
XXXXXXXXXXX
This parameter specifies the Merchant ID assigned by Paymark.
Press ENTER.
7.0
NII?
001
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press ENTER.
Proceed with the EFTPOS configuration as normal for the preferred
communication method.
8.0
SAVE CONFIG Y/N
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or CLEAR to exit and return to idle screen.
9.0
COPY CONFIG TO
ALL MERCHANT Y/N
This feature allows the merchant to copy the configuration from COMMS mode and
below to the entire active merchants if communicating through same medium.
Press ENTER to copy the current configuration to the entire active merchants or
CLEAR to cancel and proceed with configuring each merchant for its required
COMMS mode.
