IMER INTERNATIONAL S.p.A
17
18
TROUBLESHOOTING
- CAUTION!!! All maintenance operations must be
performed exclusively with the machine stopped off and
the power plug disconnected from the mains.
Problem
Causes
Corrective action
Motor fails to start
when switch is
operated
Voltage not reaching
supply line
Check the line *
Electrical socket and
plug are not properly
connected
Restore correct
connection
The power cable from
the plug to the panel is
cut off
Change the cable *
An electrical wire in the
motor terminal board is
disconnected
Restore the
connection *
An electrical wire in the
electrical panel is
disconnected
Restore the
connection *
The ON switch is faulty
Replace the switch *
The thermal safety
device has been
triggered
Wait a few minutes
and try again
Carriage does not
slide horizontally
easily
Dirty runners
Clean the runners
No cooling water
reaching disc
Refer to "cleaning and maintenance of the
cooling system" (par. 17.5)
Disc fails to cut
The disc is worn
Replace with new
disc
* Operation to be carried out by an electrician
Tools supplied
• double
-ended wrench CH 10-13
• open ended wrench CH 36
19 DISPOSAL
The saw must be disposed in accordance with current
regulations.
The barred bin symbol on the equipment
indicates that, at the end of its service life,
the product must be scrapped separately
from other materials.
The manufacturer is responsible for separate scrapping of the
equipment at the end of its service life. The user must
therefore contact the manufacturer and follow the instructions
given by the latter for separate scrapping of the equipment at
the end of its service life.
Separate scrapping for subsequent recycling, treatment and
eco-compatible disposal contributes to avoiding negative
effects for the environment and for the health of persons, and
promotes the reuse/recycling of the materials of which the
equipment is fabricated.
Incorrect/illegal scrapping is punishable by law.
