ifm
System Manual
ecomat
mobile
SmartController (CR2500) V05
Safety instructions
General
9
2 Safety
instructions
General ........................................................................................................................................9
What previous knowledge is required?......................................................................................10
2.1 General
No characteristics are warranted with the information, notes and examples provided in this manual.
The drawings, representations and examples imply no responsibility for the system and no application-
specific particularities.
The manufacturer of the machine/equipment is responsible for the safety of the machine/equipment.
WARNING
Property damage or bodily injury possible when the notes in this manual are not adhered to!
ifm electronic gmbh
does not assume any liability in this regard.
►
The acting person must have read and understood the safety instructions and the corresponding
chapters of this manual before performing any work on or with this device.
►
The acting person must be authorised to work on the machine/equipment.
►
Adhere to the technical data of the devices!
You can find the current data sheet on
ifm's
homepage at:
→
►
Note the installation and wiring information as well as the functions and features of the devices!
→
supplied installation instructions or on
ifm's
homepage:
→
ATTENTION
The driver module of the serial interface can be damaged!
Disconnecting the serial interface while live can cause undefined states which damage the driver
module.
►
Do not disconnect the serial interface while live.
Start-up behaviour of the controller
The manufacturer of the machine/equipment must ensure with his application program that when the
controller starts or restarts no dangerous movements can be triggered.
A restart can, for example, be caused by:
•
voltage restoration after power failure
•
reset after watchdog response because of too long a cycle time
