Icom ID-E880, Instruction Manual

Page: 88 / 196

70
5
DV MODE OPERATION
N
Low-speed data communication
In addition to the digital voice communication, low-speed data
communication is available.
Use the optional OPC-1529R
DATA COMMUNICATION CABLE
with
third-party serial data communication software.
NOTE: Turn OFF "GPS-TX"
(p. 138)
in advance to operate
the low-speed data communication.
D
Connection
Connect the transceiver to your PC using with the optional
OPC-1529R as illustrated below.
OPC-1529R
(optional)
to [DATA]
to RS-232C
port
D
Low-speed data communication application
setting
Configure the serial data communication software as follows.
• Port : The COM port into which you plugged the
OPC-1529R
• Baud rate : 9600/4800 bps
(p. 129)
• Data : 8 bit
• Parity : None
• Stop : 1 bit
• Flow control : Xon/Xoff
D
Low-speed data communication operation
NOTE: Confirm that when in AUTO, the computer controls
[PTT] to send data. In AUTO you should not have to push
[PTT] to send data.
q
Set the current call signs, etc. as described in “Current call
sign setting”
(p. 42),
“Simplex operation in the VFO”
(p. 56)
and “D-STAR repeater operation in the VFO”
(p. 58)
.
w
Follow the instructions for the data communication soft-
ware.
e
To transmit data
• At the same time as your voice audio, push and hold [PTT] to
transmit while sending data from the PC. Release [PTT] to re-
ceive.
• Under computer control, see Transmission condition setting at
right.