Icom ID-E880, Instruction Manual

Page: 117 / 196

99
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
The bank contents of programmed memory channels can be
cleared or reassigned to another memory bank.
INFORMATION: Even if the memory bank contents are
cleared, the memor y channel contents still remain
programmed.
q
Select the desired bank contents to be transferred or
erased from the bank.
(p. 93)
± Push [M/CALL] several times to select the memory
mode.
± Push [BAND] , then rotate [DIAL] to select the desired
memory bank group, then push [BAND] again.
± Rotate [DIAL] to select the bank channel.
• Bank initial and bank channel stops blinking.
[DIAL] [BAND]
[M/CALL] [S.MW ]
w
Push [S.MW] to enter the select memory write mode.
• Displays the original memory channel number automatically, and
then “
X
” indicator and the memory channel number blink.
• Do not hold [S.MW] (MW) for more than 1 sec., otherwise the
memory contents will be copied to the VFO.
e
Push [ ] (MONI) to select “BANK” setting, then push [ ]
(MONI) again.
r
Push [ ] (LOW) to select the bank channels selection, or
push [ ] (CS) to select the bank group selection to be trans-
ferred.
t
Rotate [DIAL] to select the desired bank group or channel.
• Push [CLR] (DR) or select “– – – –” indication when erasing the
contents from the bank.
y
After editing, push [ ] (MONI) to select “BANK” setting.
u
Push [MW] (S.MW) for 1 sec. to erase/transfer the bank
contents.
N
Erasing/transferring bank contents
[DIAL]
[CLR]
To transfer the bank contents
to channel 11 in Bank B.
Bank channel is displayed.
To erase.
“– – – –” is displayed.
[ ] [ ][ ]
[S.MW ]
7
MEMORY CHANNEL OPERATION