![background image](http://html1.mh-extra.com/html/icom/id-e880/id-e880_instruction-manual_3785265123.webp)
105
8
SCAN OPERATION
N
Memory scan
IMPORTANT:
To perform memory scan, 2 or more mem-
ory channels MUST be programmed, otherwise the scan
will not start.
q
Push
[M/CALL]
several times to select the memory mode.
w
Set the squelch level.
e
Push and hold
[SCAN]
(VFO/MHz) for 1 sec. to enter the
scanning type selection.
r
Rotate
[DIAL]
to select the desired scanning type.
• “ALL” for all memory scan; “BAND” for band memory scan,
“MODE” for mode scan, “DUP” (appears only when duplex op-
eration is set) for duplex scan, “TONE” (appears only when the
subaudible tone, tone squelch or DTCS squelch is set) for tone
scan.
[DIAL] [SCAN]
All memory scan
Band memory scan
Mode scan
Push and hold
[SCAN]
for 1 sec.,
then rotate
[DIAL]
.
Duplex scan
Selected mode is displayed.
t
Push
[SCAN]
(VFO/MHz) to start the scan.
• Scan pauses when a signal is received.
• Rotate
[DIAL]
to change the scanning direction. This also
causes the transceiver to resume scanning.
• Push
[SCAN]
(VFO/MHz) to stop the scan.
Band memory scan function:
Repeatedly scans all
memory channels programmed with any frequencies of
the band programmed in the memory channel selected for
scanning.
Mode scan function:
Repeatedly scans all memory chan-
nels in which the same operating mode as the selected
memory channel has been programmed.
Duplex scan function:
Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
During memory scan
During mode scan
8
Summary of Contents for ID-E880
Page 194: ...176 MEMO...
Page 195: ...177 MEMO...