![background image](http://html2.mh-extra.com/html/icom/ic-f62d/ic-f62d_operating-manual_4278581095.webp)
9
BIIS 1200 SYSTEM OPERATION
9-4
Transmitting a call
D
Transmitting a Status Message
You can transmit a preset Status Message� You
cannot transmit a voice call at the same time�
NOTE:
Depending on the presetting, the Priority A
channel is always used to send Status Messages�
(Menu > Signaling/Call >
Call Menu
)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select
“Signaling/Call,” then push [OK]�
Channel/Scan
►
Signaling/Call
►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select
“Call Menu,” then push [OK]�
Call List Select
►
Call Menu
►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select an
Individual or Group ID, then push [OK]�
✔
Station 1
►
✔
Group 1
►
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select “Status,”
then push [OK]�
✔
Status
►
✔
Message
►
Station 1
6� Push [P2 (Up)] or [P1 (Down)] to select a Status
Message, then push [PTT] to transmit it�
✔
TX Status 01
✔
TX Status 02
Status
• “Success” is displayed when an acknowledgment is
received from the targeted station�
• “Failed” is displayed if an acknowledgment is not
received from the targeted station�
NOTE:
If the following settings are configured using the
CS-F52D
programming
software
, the Status
Message can be automatically transmitted when:
•The transceiver is turned ON�
L
Set
Power ON Status 23
to “Enable�”
•The transceiver is turned OFF�
L
Set
Power OFF Status 19
to “Enable�”
(Analog > BIIS > Config > Status Setting)
TIP:
•You can also transmit a Status Message through
Status
�
(Menu > Signaling/Call >
Status
)
•Push [Status] to directly display the “Status” screen
in step 4 to the left�
•Hold down [Status] for 1 second to transmit the
preset Status Message that is set in the “Status”
screen�