7
NXDN™ OPERATION
7-5
D
Transmitting a Status message
You can transmit a preset simple message� You
cannot transmit a voice signal at the same time�
(Menu > Signaling/Call >
Call Menu
)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then push [OK]�
Channel/Scan
►
Signaling/Call
►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call
Menu,” then push [OK]�
Call List Select
►
Call Menu
►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select the
Individual or Group ID, then push [OK]�
✔
Station 1
►
✔
Group 1
►
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select “Status,”
then push [OK]�
✔
Status
►
✔
Message
►
Station 1
6� Push [P2 (Up)] or [P1 (Down)] to select a Status
message, then push [PTT] to transmit it�
✔
TX Status 01
►
✔
TX Status 02
►
Status
• “Success” is displayed when an acknowledgment is
received from the targeted station�
• “Failed” is displayed if an acknowledgment is not
received from the targeted station�
TIP:
•You can also transmit a Status message through
Status
�
(Menu > Signaling/Call >
Status
)
•Push [Status] to directly display the “Status” screen
in step 6 to the left�
•Hold down [Status] for 1 second to transmit the
preset Status message that is set in the “Status”
screen�
Transmitting a call
NOTE:
If the following settings are configured using
the CS-F52D
programming
software
,
the Status
message can be automatically transmitted when:
•The transceiver is turned ON or OFF
L
Set the Status message to be transmitted in
Power ON
Status
or
Power OFF Status
, respectively�
L
Set the target station ID in
Power Status ID
,
Power
Status ID for Single-site Trunk
or
Power Status ID
for Multi-site Trunk
�
( Digital > Status > Status Setting)
• After sending a voice message
L
Set
Send with Voice Call
to “Enable�”
L
Set the Status message to be transmitted in
Send
Status Number
�
( Digital > Status > Status Setting)
