![background image](http://html.mh-extra.com/html/icom/ic-7000/ic-7000_instruction-manual_611322005.webp)
ii
R
WARNING RF EXPOSURE!
This device emits
Radio Frequency (RF) energy. Extreme caution should be
observed when operating this device. If you have any
questions regarding RF exposure and safety standards
please refer to the Federal Communications Commission
Office of Engineering and Technology’s report on Evalu-
ating Compliance with FCC Guidelines for Human Radio
Frequency Electromagnetic Fields (OET Bulletin 65).
R
WARNING HIGH VOLTAGE! NEVER
attach an
antenna or internal antenna connector during transmis-
sion. This may result in an electrical shock or burn.
R
NEVER
apply AC to the [DC13.8V] socket on the
transceiver rear panel. This could cause a fire or damage
the transceiver.
R
NEVER
apply more than 16 V DC, such as a 24 V
battery, to the [DC13.8V] jack on the transceiver rear
panel. This could cause a fire or damage the transceiver.
R
NEVER
let metal, wire or other objects touch any in-
ternal part or connectors on the rear panel of the trans-
ceiver. This may result in an electric shock.
R
NEVER
connect or use the HM-151 (microphone)
with other transceiver. This could cause damage to the
transceiver. The HM-151 is designed for use with the IC-
7000
ONLY
NEVER
expose the transceiver to rain, snow or any liq-
uids.
AVOID
using or placing the transceiver in areas with tem-
peratures below –10°C (+14°F) or above +60°C (+140°F).
Be aware that temperatures on a vehicle’s dashboard can
80°C (+176°F), resulting in permanent damage
to the transceiver if left there for extended periods.
AVOID
placing the transceiver in excessively dusty envi-
ronments or in direct sunlight.
AVOID
placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct heat
dissipation.
Place unit in a secure place to avoid inadvertent use by
children.
During mobile operation,
NEVER
place the transceiver
where air bag deployment may be obstructed.
During mobile operation,
DO NOT
place the transceiver
where hot or cold air blows directly onto it.
During mobile operation,
DO NOT
operate the transceiver
without running the vehicle’s engine. When the trans-
ceiver’s power is ON and your vehicle’s engine is OFF,
the vehicle’s battery will soon become exhausted.
Make sure the transceiver power is OFF before starting
the vehicle. This will avoid possible damage to the trans-
ceiver by ignition voltage spikes.
During maritime mobile operation, keep the transceiver
and microphone as far away as possible from the mag-
netic navigation compass to prevent erroneous indica-
tions.
BE CAREFUL! The rear panel will become hot when op-
erating the transceiver continuously for long periods.
BE CAREFUL! If a linear amplifier is connected, set the
transceiver’s RF output power to less than the linear am-
plifier’s maximum input level, otherwise, the linear ampli-
fier will be damaged.
Use Icom microphones only (supplied or optional). Other
manufacturer’s microphones have different pin assign-
ments, and connection to the IC-7000 may damage the
transceiver.
Beat signals may be heard on some frequencies.
These will occur as a result of circuit construction.
For U.S.A. only
Caution:
Changes or modifications to this transceiver,
not expressly approved by Icom Inc., could void your
authority to operate this transceiver under FCC regu-
lations.
PRECAUTIONS
Summary of Contents for IC-7000
Page 1: ...HF VHF UHF ALL MODE TRANSCEIVER i7000 INSTRUCTION MANUAL ...
Page 164: ...155 MEMO ...
Page 165: ...156 MEMO ...