Icom IC-7000, Instruction Manual, Page: 59 / 166

50
4
RECEIVE AND TRANSMIT
4
D Keyer set mode (continued)
3
Rise Time
This item sets the envelop time period which the out-
put power becomes the set transmit power.
• 2, 4, 6, or 8 msec. can be selected.
• Push
[F-4
DEF
]
for 1 sec. to select a default setting.
(default: 4 sec.)
Key action
Tx output power
• About rise time
Rise time
Tx
Rx
Set Tx power level
Time
0
4
Paddle Polarity
This item sets the paddle polarity.
• Normal and reverse polarity can be selected.
• Push
[F-4
DEF
]
for 1 sec. to select a default setting.
(default: Normal)
5
Keyer Type
This item selects the keyer type for
[KEY]
connector
on the rear panel.
• ELEC-KEY, BUG-KEY and Straight key can be se-
lected.
• Push
[F-4
DEF
]
for 1 sec. to select a default setting.
(default: ELEC-KEY)
6
MIC U/D Keyer (HM-103)
(Microphone’s
[UP]
/
[DN]
switches keyer)
This item allows you to set the microphone
[UP]
/
[DN]
switches to be used as a paddle.
• ON :
[UP]
/
[DN]
switches can be used for CW.
• OFF:
[UP]
/
[DN]
switches cannot be used for CW.
• Push
[F-4
DEF
]
for 1 sec. to select a default setting.
(default: OFF)
NOTE:
When “ON” is selected, the frequency and
memory channel cannot be changed using the
[UP]
/
[DN]
switches.
Connect a CW paddle as at right to operate an elec-
tronic keyer from [MIC] connector.
• This function is available from both of the front panel
and rear panel mic connector.
• Be sure to select “Paddle Polarity” and “Keyer Type”
in the keyer set mode. (see above)
• Connect straight key to “DOT” side.
MIC connector
MIC U/D
CW
paddle
DOT
E
DASH
w
u
3.9 k
1
± 5%
2.2 k
1
± 5%
D Paddle operation from [MIC] connector