Icom IC-7000, Instruction Manual, Page: 124 / 166

115
9
SCAN OPERATION
q
Select VFO mode, then set a frequency.
w
Close the squelch with
[RF/SQL]
.
e
Set the desired memory channel as the watching
channel.
r
Select
S-2
.
t
Push
[F-2
PRI
]
to start the priority watch.
• “ ” appears and decimal point blink while scanning.
y
When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.
u
To cancel the scan push
[F-2
PRI
]
.
NOTE:
The paused condition when detecting a sig-
nal differs depending on the scan resume condi-
tion. (p 134)
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.
Select
VFO mode.
Select watching
channel.
Push [F-2
PRI
].
[MENU/GRP] [F-2]
[RF/SQL]
Appears while scanning
q
Select
S-2
.
w
Push
[F-3
V/M
]
to select memory mode.
e
Close the squelch with
[RF/SQL]
.
r
Push
[F-1
SCN
]
to start the memory scan.
• Decimal point blinks while scanning.
t
Push
[F-2
SEL
]
to change the memory scan to se-
lect memory scan.
y
When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u
To cancel the scan push
[F-1
SCN
]
.
NOTE:
Two or more memory channels must be
designated as select memory channels for select
memory scan to start (see p. 106).
While scan function is not activate, pushing
[F-2
SEL
]
sets the select memory channels ON or OFF.
And pushing and holding
[F-2
SEL
]
for 2 sec.
clears the all select memory channels.
Designate
“
★ .”
Select
memory mode.
Push [F-1
SCN
],
then push [F-2
SEL
].
[MENU/GRP] [F-1] [F-2] [F-3]
[RF/SQL]
■
Select memory scan operation
■
Priority watch
Menu group selection
Push
[MENU/GRP]
for 1 sec.
Selection from:
M
,
S
or
G
(Graphic)
Menu selection (Example: M)
Push
[MENU/GRP]
momentarily.
Selection from:
S-1
,
S-2
or
S-3
Either
Y or Z
Either
Y or Z