Icom IC-7000, Instruction Manual, Page: 123 / 166

114
9
SCAN OPERATION
9
q
Select
S-2
.
w
Push
[F-3
V/M
]
to select VFO mode.
e
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r
Set
[RF/SQL]
open or closed.
• See page a left for squelch condition.
• If the
[RF/SQL]
control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 1, 35, 131 for details.
t
Push
[F-1
SCN
]
to start the scan.
• Decimal point blinks while scanning.
y
When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
u
To cancel the scan push
[F-1
SCN
]
.
NOTE:
If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
Select
VFO mode
then push [F-1
SCN
]
[MENU/GRP] [F-1] [F-3]
[RF/SQL]
■ Programmed scan operation
q
Select the desired memory bank, if necessary.
●
●
Push
[PBT/M-ch/RIT]
momentarily to select the
M-ch/RIT function, if the twin PBT is selected.
•
[PBT/M-ch/RIT]
indicator (Green) goes out.
● ●
Rotate
[RIT]
(outer) control to select the desired
memory bank.
w
Select
S-2
.
e
Push
[F-3
V/M
]
to select memory mode.
r
Close the squelch with
[RF/SQL]
.
t
Push
[F-1
SCN
]
to start the scan.
• Decimal point blinks while scanning.
y
When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u
To cancel the scan push
[F-1
SCN
]
.
NOTE:
Two or more memory channels must be
programmed for memory scan to start.
Select
memory mode
then push [F-1
SCN
]
[MENU/GRP] [F-1] [F-3]
[RF/SQL]
[RIT] (outer) control
■
Memory scan operation
Menu group selection
Push
[MENU/GRP]
for 1 sec.
Selection from:
M
,
S
or
G
(Graphic)
Menu selection (Example: M)
Push
[MENU/GRP]
momentarily.
Selection from:
S-1
,
S-2
or
S-3
Either
Y or Z
Either
Y or Z