Icom IC-2820H, Instruction Manual

Page: 96 / 164

75
8
SCAN OPERATION
■
Scan start/stop
D
Preparation
Scan resume condition
(p. 78)
; program the scan edges
(pgs. 76, 77)
; program 2 or more memory channels
(pgs. 62,
63)
; set skip settings, if desired
(p. 79)
.
D
Operation
q
Select VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•MW] in the desired band
(Left or Right)
.
• Select the desired bank with the same band’s [MAIN•BAND] for
bank scan.
w
Push and hold the same band’s [V/MHz•SCAN] for 1 sec.
e
Rotate the same band’s [DIAL] to select the scan type
from ALL and programmed scan
(PROG 0 to PROG 9)
, if
VFO is selected in step
q
.
r
Push the same band’s [V/MHz•SCAN] momentarily to start
the scan.
• To change the scanning direction, rotate the same band’s [DIAL].
• The memory channel readout blinks the scan type as follows:
t
To stop the scan, push the same band’s [V/MHz•SCAN].
z
Push [VFO/LOCK] to select VFO mode for
full/programmed scan; push [MR/CALL] to select
memory mode for memory scan, in the main
band.
• Push [FUNC] then [
MONI
1(BANK)] to select a bank
for bank scan.
x
Push [
SCAN
2(T-SCAN)].
c
Push [
Y
] or [
Z
] to select the ALL and pro-
grammed scan
(PROG 0 to PROG 9)
, if VFO is se-
lected in step
z
.
v
Push [
SCAN
2(T-SCAN)] again to start the scan.
• Push [
Y
] or [
Z
] for 1 sec. also starts the scan.
b
To stop the scan push [
SCAN
2(T-SCAN)] or
[
CLR
A(MW)].
SCAN
2
• During full scan • During programmed scan • During memory scan • During bank scan
Indicates scan edge channels.
• P1 stands for 1A/1B Indicates bank initial. Rotate [DIAL] to select “ALL”
(full) or programmed scan (P1
to P9) in sequence.