IBM System x3300 M4, Installation And Service Manual

Page: 366 / 470

10. Close the bezel.
11.
Lock the left-side cover.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 104
Removing a 3.5-inch simple-swap hard disk drive:
Before removing a 3.5-inch simple-swap hard disk drive, read the following
information:
v
Inspect the drive tray for signs of damage.
v
To maintain proper system cooling, do not operate the server for more than 10
minutes without either a drive or a filler panel installed in each drive bay.
v
You have to turn off the server to install simple-swap drives in the simple-swap
drive bays.
To remove a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins “Safety” on page vii and “Installation
guidelines” on page 36
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
3.
Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
4. Open the bezel (see “Removing the bezel” on page 331).
5. Move the release latch to open position and grasp the drive handle to pull the
3.5-inch simple swap drive out of the drive bay of the server.
348
System x3300 M4 Type 7382: Installation and Service Guide