IBM SAN512B-6, Installation, Service And User Manual

Page: 67 / 286

1. Power cable
2. Connector latch
8. Attach the cable restraint cover under the power cord connector using its two
torx head screws (refer to step 4).
Note: This retainer cover protects the power cord from being accidentally
unlatched and disconnected from the power supply.
9. If connecting to an AC power source, use the following steps. (If connecting to
a DC power source, go on to step 8.)
a. Make sure that you observe the electrical caution and danger statements in
“Safety precautions” on page 7 when connecting this power supply.
b. Make sure that AC power plug is attached to the power-source end of the
HVAC/HVDC power cord that meets your facility and local code
requirements. For more information on the HVAC/HVDC power cord
available for these power supplies, refer to “Using HVAC/HVDC power
cords” on page 45.
Chapter 4. Initial Setup and Verification
43
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|