IBM SAN512B-6, Installation, Service And User Manual

Page: 221 / 286

Gateway Address: 14.25.43.1
Backplane IP address of CP0 : 14.11.0.6
Backplane IP address of CP1 : 14.11.0.7
switch:admin>switch:admin>
6. Display and record the manufacturer serial numbers.
Enter
chassisShow
, and then copy the command output into the
config-miscinfo.txt file.
"Factory Serial Num" and "Serial Num" are listed under "Chassis/WWN Unit
1" and "Chassis/WWN Unit 2". If the current WWN cards are the original
cards, the factory serial number listed is the same as the chassis serial number.
For example output from the
chassisShow
command, refer to “switchShow”
on page 99.
7. Create a SAN "profile" by entering and recording the information provided by
the following commands:
v nsShow
v
nsAllShow
v switchShow -qsfp
v
fabricShow
Copy the command output into a text file named "SANbefor.txt." After the
device is restored to the fabric, this information can be used to verify that no
unintentional changes have occurred to the fabric.
switch:admin> nsshow
Enter Pid COS PortName NodeName TTL
<output truncated>
switch:admin> nsallshow
12 Nx_Ports in the Fabric
<output truncated>
switch:admin> switchshow
switchName: switch
<output truncated>
switch:admin> fabricshow
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
<output truncated>
switch:admin>
8. Enter licenseShow , and then copy the command output into a text file named
"licenseshow.txt."
switch:admin> licenseshow
S9bddb9SQbTAceeC:
Fabric license
eezeRRySff0fSe:
Remote Switch license
bzbzRcbcSc0c0SY:
Remote Fabric license
dSeR9RcSeeTfSAq:
Extended Fabric license
RyeSzRScycTzfT09:
Entry Fabric license
RyeSzRScycazfT0G:
Trunking license
RyeSzRScycS0fT09:
4 Domain Fabric license
9. Enter supportShow ; then copy the command output into a text file named
"spptshow.txt."
Note:
The
supportShow
command has a very long output and time for
completion. It may last 20 minutes or longer depending on the size of the
SAN.
Chapter 16. Replacing the Chassis
197