IBM SAN512B-6, Installation, Service And User Manual

Page: 225 / 286

The WWN units should indicate "Non-portside Intake." If there is a mismatch
of airflow direction, RASlog messages will indicate a mismatch between system
airflow direction and airflow direction of fan in power supply or fan assembly
refer to “Configuring airflow direction on WWN cards” on page 157 for
instructions on configuring correct airflow direction on WWN cards.
3. Enter the
slotShow -m
command and verify that all the installed cards are
detected and that their status is operational (enabled).
switch:admin> slotShow -m
Slot
Blade Type ID Model Name Status
--------------------------------------------------
1 CP BLADE 175 CPX6 ENABLED
2 CP BLADE 175 CPX6 ENABLED
3 SW BLADE 178 FC32-48 ENABLED
4 SW BLADE 178 FC32-48 ENABLED
5 AP BLADE 186 SX6 ENABLED
6 SW BLADE 178 FC32-48 ENABLED
7 CORE BLADE 176 CR32-8 ENABLED
8 CORE BLADE 176 CR32-8 ENABLED
9 SW BLADE 178 FC32-48 ENABLED
10 AP BLADE 186 SX6 ENABLED
11 SW BLADE 178 FC32-48 ENABLED
12 SW BLADE 178 FC32-48 ENABLED
switch:admin>
4. Verify that the device is functioning correctly by entering
switchShow
or
switchStatusShow
.
This switchShow command displays the device and port status information.
switch15:admin> switchshow
switchshow>
switchshow
switchName: sw15
switchType: 166.0
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 1
switchId: fffc01
switchWwn: 10:00:00:23:f8:f2:15:82
zoning: ON (MPR4k)
switchBeacon: OFF
FC Router: OFF
FC Router BB Fabric ID: 128
Address Mode:
0
Fabric Name: BB1
HIF Mode: OFF
Index Slot Port Address Media Speed State Proto
=======================================================
0 3 0 010000 id 32G Online FC F-Port 20:00:00:27:f8:f3:15:80
1 3 1 010100 id 32G Online FC F-Port 20:01:00:27:f8:f3:15:80
2 3 2 010200 id 32G Online FC F-Port 20:02:00:27:f8:f3:15:80
3 3 3 010300 id 32G Online FC F-Port 20:03:00:27:f8:f3:15:80
4 3 4 010400 id 32G Online FC F-Port 20:04:00:27:f8:f3:15:80
5 3 5 010500 id 32G Online FC F-Port 20:05:00:27:f8:f3:15:80
6 3 6 010600 id 32G Online FC F-Port 20:06:00:27:f8:f3:15:80
(output truncated)
5. Verify that all the IP address information is correct by entering
ipAddrShow
and
checking the results against the IP information recorded in the
config-miscinfo.txt file.
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: xxx.xxx.xxx.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
Chapter 16. Replacing the Chassis
201