IBM SAN512B-6, Installation, Service And User Manual

Page: 239 / 286

1. Ensure that the rack is in the correct location.
2.
In this rack, temporarily install the bushings to help position the
rack-mounting plates.
3. Ensure that the bushing is in the leveling foot. Position the two rack-mounting
plates in the approximate mounting locations under the rack. If necessary,
raise the leveling feet for clearance.
4. Place a bushing on a rack-mounting bolt. Insert the bolt and bushing through
the leveling foot and bushing, and out of the bottom bushing.
5. Insert the four rack-mounting bolts through the leveling feet and bushings,
and out the bottom of the rack.
6. Position the rack-mounting plates under the four rack-mounting bolts. Center
the rack-mounting bolts directly over the tapped holes.
7.
Turn the rack-mounting bolts 3–4 rotations into the tapped holes.
8. Mark the raised-floor panel around the edges of both rack-mounting plates.
9. Mark the rack-mounting plate bolt-down holes that are accessible through the
opening in the rear of the rack.
10. Remove the rack-mounting bolts and bushings.
11. Remove the rack-mounting plates.
12. Loosen the locking screws on the casters. Move the rack so that it is clear of
the locator marks for the rack-mounting plates.
13. Position the rack-mounting plates within the marked areas.
14. Mark the raised-floor panel at the center of each hole in the rack-mounting
plates (including the tapped holes).
15. Remove the two rack-mounting plates from the marked locations.
16.
Transfer the locations of the holes from the raised-floor panel to the concrete
floor directly beneath. Mark the holes on the concrete floor.
Mounting
Hole (4X)
Bolt (4X)
Washer (4X)
Thick Washer (4X)
Spacer (4X)
Jam Nut (4X)
Leveler (4X)
Bushing (8X)
Mounting
Plate (2X)
Location
Mark (Drill)
Tapped Hole for
Rack Mounting
Hole for
Anchor Bolts
SJ000657
Figure 66. Attaching the rack to a raised floor
Appendix A. SAN rack
215
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|