IBM SAN512B-6, Installation, Service And User Manual

Page: 80 / 286

sb_70:admin> configupload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 192.168.0.100
User Name [user]: anonymous
Path/Filename [<home dir>/config.txt]: /dumps/supportsave/pz/switch85/G20-1.txt
Section (all|chassis|switch [all]): all
configUpload complete: All selected config parameters are uploaded
4. Back up the virtual fabric configuration using the configUpload -vf command.
For more information on using the
configUpload
and
configUpload -vf
command, refer to the Fabric OS Command Reference.
5. Enter the following commands for additional configuration information that
you can save to files:
v configShow
v ipaddrShow
v licenseShow
v
switchShow
Powering down the chassis
About this task
Perform the following steps to power down the chassis.
Procedure
1. Shut down the chassis using the sysShutdown command.
switch::admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]?y
HA is disabled
Stopping blade 1
Shutting down the blade....
Stopping blade 2
Shutting down the blade....
Stopping blade 8
Shutting down the blade....
Broadcast message from root (pts/1) Tue Aug 23 14:23:06 2010...
The system is going down for system halt NOW !!
Note: If you do not use the sysshutdown command and you sequence power
off on power distribution units (PDU) with a few seconds between power-offs,
be aware that a low-power condition will be detected and logged along with
possible blade power-offs before shutdown. This is an expected error condition
due to delays in powering down PDUs without halting the control processors
first using
sysShutdown
2. Power off the chassis by disconnecting all power cords or switching off rack
power source.
Note that power supply LEDs will continue to flash green briefly after
disconnecting power until power supply is completely off.
56
SAN512B-6 Installation, Service, and User Guide