IBM IntelliStation E Pro, Hardware Maintenance Manual

Page: 90 / 182

1. Turn off the computer and attached devices; then, disconnect all external cables
and power cords.
2. Remove the cover (see“Removing the cover of the 6216” on page 45.
3. Rotate the retainer up and pull the adapter retainer away from the chassis.
To install the adapter retainer, reverse the previous steps, sliding the two side knobs
on the retainer into the channels provided for them on the chassis and positioning
the retainer so that the plastic tabs are pressed against the inside of the PCI slot
covers.
Fan
Note: Read “Before you begin” on page 41 and the safety notices at “Safety
information” on page 129.
Complete the following steps to remove the fan:
1. Turn off the computer and attached devices; then, disconnect all external cables
and power cords.
2. Remove the cover and the frame-support bracket (see“Removing the cover of
the 6216” on page 45 and “Removing the frame-support bracket” on page 45).
3. Remove the air baffle (see “Baffle” on page 79).
4. Disconnect the fan cable from the system board.
Release
latch
Retainer slots
5. Push the two of the four tabs on the right of the chassis toward the rear, and
then push in until the fan is released. Pull the fan out of the computer.
6. Pull the fan up and out of the chassis.
To install the rear fan, reverse the previous steps.
Operator information panel
Note: Read “Before you begin” on page 41 and the safety notices at “Safety
information” on page 129.
80
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual