IBM IntelliStation E Pro, Hardware Maintenance Manual

Page: 91 / 182

Complete the following steps to remove the operator information panel:
1. Turn off the computer and attached devices; then, disconnect all external cables
and power cords.
2. Remove the cover and the frame-support bracket (see“Removing the cover of
the 6216” on page 45 and “Removing the frame-support bracket” on page 45).
3. Swing the CD-ROM drive cage up.
4. Disengage the operator information panel cable from the system board.
5. Press upward on the lower tab of the operator information panel until it comes
loose.
Note: It might be necessary to use the tip of a screwdriver to disengage the
lower tab.
Release
latch
Retainer slots
6. Push inward on the two tabs of the top section of the operator information panel
until it pops free of the chassis; then, remove it from the computer, making sure
that the cable follows freely.
To install the operator information panel, reverse the previous steps.
Speaker
Note: Read “Before you begin” on page 41 and the safety notices at “Safety
information” on page 129.
Complete the following steps to remove the speaker:
1. Turn off the computer and attached devices; then, disconnect all external cables
and power cords.
2. Remove the cover and the frame-support bracket (see“Removing the cover of
the 6216” on page 45 and “Removing the frame-support bracket” on page 45).
3. Rotate the diskette drive cage to its vertical position.
FRU information (service only)
81