Novell NetWare or IntraNetWare system ODI driver messages
This section explains the error messages for the Novell NetWare or IntraNetWare
system ODI driver, and suggested actions to resolve each problem.
Message
Description
Could not allocate resources.
Explanation:
An unknown error has occurred when trying to allocate needed
resources for the AFT Module.
Action:
v
Check the system configuration. If the problem remains, contact the
network supplier.
v
Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
AFT group for primary adapter in slot
nnn
already exists.
Explanation:
An attempt was made to rebind an adapter already in an AFT
group.
Action:
Check the AFT slot numbers for existing AFT teams. If the problem
remains, contact the network supplier.
Error locating device control table
(DCT) addresses in internal table.
Make sure that you have loaded LAN
drivers after loading AFT.NLM.
Explanation:
The bind command was entered prior to loading the device
driver. The device driver must be loaded after loading AFT.NLM, but before
any bind command can be issued.
Action:
Load the driver for the supported adapter and try loading the AFT
module again. If the problem remains, contact the network supplier.
Insufficient number of arguments
specified.
Explanation:
The appropriate or expected number of parameters was not
entered in a command.
Action:
Check the parameters required for the given command. If the
problem remains, contact the network supplier.
Duplicate slot numbers detected.
Explanation:
An attempt has been made to bind the same slot number more
than once.
Action:
Check the slot numbers entered during the bind. Adapter slot
numbers must be valid and unique. If the problem remains, contact the
network supplier.
’
xxx
’ is not supported for AFT team.
Explanation:
A bind command has been issued for adapters not supported
by AFT.NLM.
Action:
Make sure that you attempt to bind only adapters supported by
AFT.NLM.
Primary and Secondary adapters do
not match. AFT group is not created.
Explanation:
A bind command was entered for an adapter team that is a
combination of system and client adapters. An AFT team must be a grouping
of the same classification of adapter.
Action:
Verify that all the adapters bound in a team are of the same
classification.
Requested number of Secondary
cards are not found.
Explanation:
The number of adapters specified in the bind command could
not be located.
Action:
Verify the numbers and slot locations of the adapters to be bound. If
the problem remains, contact the network supplier.
Failed to create AFT group. Make
sure that the drivers for supported
adapters are loaded, primary adapter
is bound to protocols, and secondary
adapter is not bound to any protocols.
Explanation:
Binding of protocol failed. Protocol is either not bound to any
adapter or is bound to more than one adapter in the group.
Action:
Ensure that the protocol is bound to only one adapter in an AFT
team.
34
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
Summary of Contents for IntelliStation E Pro
