IBM IntelliStation E Pro, Hardware Maintenance Manual

Page: 89 / 182

FRU information (service only)
The field replaceable unit (FRU) procedures are intended for trained servicers who
are familiar with IBM products.
IntelliStation E Pro Type 6216
The following section contains information about removing components of the
IntelliStation E Pro Type 6216.
Baffle
Note: Read “Before you begin” on page 41 and the safety notices at “Safety
information” on page 129.
Complete the following steps to remove the baffle:
1. Turn off the computer and attached devices; then, disconnect all external cables
and power cords.
2. Remove the cover and the frame-support bracket (see“Removing the cover of
the 6216” on page 45 and “Removing the frame-support bracket” on page 45).
Release tabs
3. Grasp the baffle on the top and bottom of the wide end and squeeze gently;
then, pull the baffle up and away from the back of the chassis.
4. When the baffle is free of the back of the chassis, lift it out of the computer.
To reinstall the baffle, set the two pins on the bottom of the baffle into the slots
provided for them in the chassis; then, gently squeeze the baffle near the two tabs
on the top of the baffle so that the tabs slide into the two notches provided for
them.
Adapter retainer
Note: Read “Before you begin” on page 41 and the safety notices at “Safety
information” on page 129.
Complete the following steps to remove the adapter retainer:
© Copyright IBM Corp. 2002
79