IBM E027SLL-H - Tivoli Monitoring - PC, Troubleshooting Manual

Page: 185 / 310

The Tivoli Enterprise Monitoring Server start task (CANSDSST
default) encountered error message 'KLVST044 LOADLIST
MEMBER NOT FOUND IN RKANPAR DATASET (KDSLLIST)
KppLLIST KLVST001 CANDLE ENGINE INITIALIZATION
ERROR(S), ABEND U0012' in the RKLVLOG at startup
About this task
The Tivoli Enterprise Monitoring Server start task (CANSDSST default)
encountered error message "KLVST044 LOADLIST MEMBER NOT FOUND IN
RKANPAR DATASET (KDSLLIST) KppLLIST KLVST001 CANDLE ENGINE
INITIALIZATION ERROR(S), ABEND U0012" in the RKLVLOG at startup. Ensure
the following conditions:
v
The pp#2xxxx RTE Load job ran successfully for this RTE:
1.
To perform the RTE Load, place the L option next to the RTE on the
KCIPRTE RTE main menu. The Configuration tool generates the pp#2xxxx
RTE Load job.
2. Submit the RTE Load job. The RTE Load job populates the &rhilev.&RTE.RK*
runtime libraries by copying required elements from the SMP/E target
high-level qualifiers (&thilev.TK*).
v
If the RTE Load job was performed, then the job references the &thilev.TK*
SMP/E target datasets from where the members are copied. Ensure the datasets
are correct SMP/E target datasets where &svhilev.CSI is installed.
v
If the RTE Load job does not reference any &thilev.TK* SMP/E target datasets or
generates an incomplete RTE Load job, then ensure that the Configuration tool
references the correct SMP/E target high-level qualifiers. The Configuration tool
only generates appropriate IEBCOPY TK*-->RK* steps for SMP/E target datasets
that it can access.
Use the following steps to ensure that the Configuration tool references the correct
SMP/E target high-level qualifiers:
1. From the Configuration tool main menu, select Install products or
maintenance > Set up product or maintenance environment > Specify
environment information .
2. Verify that the values for the high-level qualifiers are correct. If the high level
qualifiers values are not the correct, use the following steps to unlock the
SMP/E high-level qualifiers:
a.
Run &shilev.INSTLIB.
b. On the Installation tool main menu, select Services and utilities > Unlock
SMP/E high-level qualifiers .
c. Specify Y on the Unlock SMP/E high-level qualifiers? field.
d. Edit the high-level qualifier modifications on the Specify installation
environment information panel.
3. Go to the RTE main menu and regenerate the RTE Load job.
KDS Parameters not generated from the batch parm deck
If you try to clone an RTE through Create Batch Mode parameters processing KDS
variables (for example, KDS_CMS_TYP) are not generated in the output. A possible
workaround is to manually add the missing parameters.
The problem is that the KCITVARS ISPF table is out of order. The procedure to sort
the table is:
Chapter 9. Monitoring server troubleshooting
167