IBM DR550, Problem Determination And Service Manual

Page: 74 / 258

Table 7. Symptom-to-FRU index (continued)
Problem
indicator Component Possible cause Possible solutions
All green LEDs
are off.
All CRUs Subsystem power is
off
Check that all storage subsystem
power cables are plugged in and
the power switches are on. If
applicable, check that the main
circuit breakers for the rack are
powered on.
AC power failure Check the main circuit breaker
and AC outlet.
Power supply
failure
Replace the power supply.
Amber LED is
flashing.
Drive CRUs
(Fault LED lit)
Drive identity is in
process.
No corrective action needed.
RAID
controller port
bypass
A fibre channel
loop initialization
process (LIP) is
being generated in
the drive loop due
to a faulty
component.
Use the Read Link Status
window in the Storage Manager
Client Subsystem Management
window and the storage
subsystem event logs to isolate
the faulty component.
Controller
drive port
bypass LED
The enclosure
speed was set to 4
Gbps but the SFP
inserted in the
controller drive SFP
port does not
operate at 4 Gbps.
Use the Recovery Guru menu
function in the Storage Manager
Client Subsystem Management
window to verify the problem
and replace the SFP with a 4
Gbps SFP.
General Fault
LED (located
on the front of
the storage
subsystem)
An intermittent
failure in the DR550
Storage Controller
subsystem
configuration. The
problem could be
directly related to
the hardware in the
configuration (hard
drive or bad cable)
or indirectly related
to the DR550
Storage Controller
subsystem
configuration (such
as a fibre channel
host bus adapter
failure in the host
server or the fibre
channel switch in
the SAN causing
LUNs to be on a
non-preferred
path.)
Use the Recovery Guru menu
function in the Storage Manager
Client Subsystem Management
window to diagnose the
problem.
46
DR550 Version 4.5 Problem Determination and Service Guide